
Specifications |
EIB 741 EIB 742 |
||
Encoder inputs |
D-sub connections, 15-pin, female (X11 to X14), for four encoders |
||
Interface (switchable) |
1 VPP ( 11 µAPP upon request) |
EnDat 2.1 |
EnDat 2.2 |
Voltage supply for encoders |
DC 5.12 V ±0.15 V; max. 450 mA per channel Overcurrent protection (automatic switch-off, resettable) at 550 mA |
||
Input frequency |
≤ 500 kHz |
– |
– |
Subdivision factor |
4096-fold |
– |
– |
Signal adjustment |
Automatic adjustment of offset, phase and amplitude |
– |
– |
Cable length1) |
≤ 150 m |
≤ 150 m |
≤ 100 m |
Data register for measured values |
48 bits (only 44 bits are used) |
||
Interval counter |
Derived from axis 1 (only 1 VPP)5), Interpolation factor can be set from 1-fold to 100-fold Can be used as trigger source or additional counting axis |
– |
– |
Measured-value memory |
Typically 250,000 position values per channel |
||
Measured-value trigger2) |
Storage of the measured values of the four axes alternatively through external or internal trigger. External: • Signal via trigger input Internal: • Timer |
||
Trigger input3) |
D-sub connection, 9-pin, male Differential inputs as per RS-485, (terminating resistors can be activated) |
||
Trigger output3) |
D-sub connection, 9-pin, female 4 differential outputs as per RS-485 |
||
Access to measured values |
Depends on the selected operating mode (see separate table) |
||
Software |
|
||
Data interface4) |
Ethernet as per IEEE 802.3 (10/100/1000 Mbit/s) |
||
Network address |
Automatic assignment through Dynamic Host Configuration Protocol (DHCP) or manual assignment |
||
Dimensions |
≈ 213 mm x 152 mm x 42 mm |
||
Operating temperature Storage temperature |
0 °C to 45 °C 0 °C to 70 °C |
||
Voltage supply |
EIB 741: AC 100 V to 240 V (±10 %), 50 Hz to 60 Hz (±2 %), power consumption approx. 30 W EIB 742: DC 24 V (-15 %/+20 %), max. 2 A |
||
1) The supply voltage range of the encoder must be maintained; specified cable length applies when HEIDENHAIN cables are used. 2) Various trigger sources can be assigned to the individual axes. 3) Can also be used as logical input or output. 4) The quality of the data cable between EIB and PC must be adapted to the transmission rate and cable length. 5) Maximum input frequency during referencing 70 kHz Remark: The available functions can be expanded by updating the firmware. |